Table 1 Recommended print settings for... | Emerald Publishing

Table 1

Recommended print settings for printing of the soluble molds in PrusaSlicer software

Setting	Recommended value	Additional notes
Layer height	0.1 mm	0.15 to 0.2 mm is adequate for some neurons
Nozzle diameter	0.3 mm or 0.4 mm
Support material	Enabled	Support from build plate only
Nozzle temperature	200°C	Supplier dependent
Bed temperature	60°C	Supplier dependent
Infill quality	Avoid crossing perimeters	Reduces stringing inside of the mold channels

Setting	Recommended value	Additional notes
Layer height	0.1 mm	0.15 to 0.2 mm is adequate for some neurons
Nozzle diameter	0.3 mm or 0.4 mm
Support material	Enabled	Support from build plate only
Nozzle temperature	200°C	Supplier dependent
Bed temperature	60°C	Supplier dependent
Infill quality	Avoid crossing perimeters	Reduces stringing inside of the mold channels

Source:

Table by authors