Principle Cura print settings used for slicing.
| Layer height | 0.25 mm |
| Line width | 0.4 mm |
| Wall thickness | 1.2 mm |
| Top/bottom thickness | 0.75 mm |
| Infill density | 20% |
| Infill pattern | Zig zag |
| Print temperature | 235°C (PETG) |
| Build plate temperature | 75°C |
| Top/bottom print speed | 30 mm/s |
| Print speed | 50 mm/s |
| Travel speed | 100 mm/s |
| Build plate adhesion | None |
| Supports* | None* |
| If supports necessary | |
| Placement | Touching build plate |
| Overhang angle | 45° |
| Pattern | Zig zag |
| Density | 15% |
| Layer height | 0.25 mm |
| Line width | 0.4 mm |
| Wall thickness | 1.2 mm |
| Top/bottom thickness | 0.75 mm |
| Infill density | 20% |
| Infill pattern | Zig zag |
| Print temperature | 235°C (PETG) |
| Build plate temperature | 75°C |
| Top/bottom print speed | 30 mm/s |
| Print speed | 50 mm/s |
| Travel speed | 100 mm/s |
| Build plate adhesion | None |
| Supports* | None* |
| If supports necessary | |
| Placement | Touching build plate |
| Overhang angle | 45° |
| Pattern | Zig zag |
| Density | 15% |
Sharing content requires targeting cookies to be enabled. Please update your cookie preferences to use this feature.