Figure 6.
The upper plot shows shaft resistance in kilopascals versus elevation from about 1 to negative 80 metres A H D. A stepped black line represents estimated values, while red square markers with dashed connections show interpreted test values. Resistance increases in steps with depth, with higher values below negative 60 metres. The lower plot shows a similar comparison for the lower pile section between about negative 79.6 and negative 85.6 metres A H D, where blue square markers align near a vertical trend, and the black line indicates a lower estimated profile.Plot of strain versus reduced level (lower pile)
Note: This figure presents the measured strains under maximum sustained tested loads of 37.73 MN for low section of pile