Figure 6
A diagram illustrating the steps to install a connector in a battery housing. The diagram includes four panels showing the sequence of steps. Panel 1 shows the battery housing positioned horizontally with the side with the elevation on the left. Panel 2 shows the placement of screw T20 M4x10mm and connector 18 into the battery housing. Panel 3 shows the connector 18 being placed in the battery housing and the screw being tightened slightly by hand. Panel 4 shows the connector 18 being screwed tight. The diagram also includes a list of tools and parts needed, such as a Cleco tool, torque bit T20, the base, screw T20 M4x10mm, and connector 18. A note advises to keep the connector wire facing you and not to tighten the screw all the way.Example of paper-based work instructions. Translation: 1. Make sure the battery housing is horizontal in front of you, the side with the elevation on your left; 2. Take screw T20 M4x10mm and connector 18; 3. Place connector 18 in the battery housing and tighten the screw slightly by hand; 4. Screw connector 18 tight. Note: keep the connector wire facing you and do not tighten the screw all the way. Source: Authors’ own work