Article navigation
Volume 22, Issue 10
1 October 1950
This article was originally published in
Aircraft Engineering
Aircraft Engineering Cover Image for Volume 22, Issue 10
Review Article| October 01 1950

An Inexpensive Cutting Tool: A New Method of Blanking Development by the Boeing Airplane Company

E. Carpenter
Tool‐Design Research Engineer, Boeing Airplane Co.
Search for other works by this author on:
This Site
PubMed
Google Scholar
Author & Article Information
Publisher: Emerald Publishing
Online ISSN: 2059-9366
Print ISSN: 0002-2667
© MCB UP Limited
1950
Aircraft Engineering (1950) 22 (10): 309.
https://doi.org/10.1108/eb031956

IN the Boeing factory today stack after stack of shiny duralumin and stainless‐steel ‘cookies’ are being sliced out of raw stock in the same way that cooks used to slice them out of dough.

This content is only available via PDF.
© MCB UP Limited
1950
You do not currently have access to this content.
Don't already have an account? Register

Purchased this content as a guest? Enter your email address to restore access.

Pay-Per-View Access
$39.00
Rental
This article is also available for rental through DeepDyve. Read this now at DeepDyve
116 Views

New and popular articles

A fail-safe decision-support framework for onboard greywater reuse in commercial aircraft water systems
Dual-state estimation of electric vertical take-off and landing batteries: data-driven modeling and experimental verification
Development of 7XXX-Al series composite materials using high-speed mechanical alloying
Inverse finite element framework for aeroelastic integration of black-box subsystems under intellectual property constraints

Recommended for you

These recommendations are informed by your reading behaviors and indicated interests.

Cited By

Google Scholar
This Feature Is Available To Subscribers Only

or Create an Account

Close Modal
Close Modal