Skip to Main Content
Article navigation
Volume 29, Issue 11
1 November 1957
This article was originally published in
Aircraft Engineering
Aircraft Engineering Cover Image for Volume 29, Issue 11
Review Article| November 01 1957

The Detection of Fatigue Cracks in Specimens under Dynamic Loading: An Electrical Circuit Method for Metallic Materials Available to Purchase

J.R. Linge, D.C.Ae., A.F.R.Ae.S.
J.R. Linge, D.C.Ae., A.F.R.Ae.S.
Test Engineer, Experimental Stress Analysis. Structural Test
Search for other works by this author on:
This Site
PubMed
Google Scholar
Author & Article Information
Publisher: Emerald Publishing
Online ISSN: 2059-9366
Print ISSN: 0002-2667
© MCB UP Limited
1957
Aircraft Engineering (1957) 29 (11): 334–342.
https://doi.org/10.1108/eb032890

THE application of cemented wires to determine the location of initial failure in static tests on large specimens has been investigated, among others, by R. W. Powell in 1946.

This content is only available via PDF.
© MCB UP Limited
1957
You do not currently have access to this content.
Don't already have an account? Register

Purchased this content as a guest? Enter your email address to restore access.

Please enter valid email address.
Email address must be 94 characters or fewer.
Pay-Per-View Access
$39.00
Rental
This article is also available for rental through DeepDyve. Read this now at DeepDyve
113 Views
View Metrics
Robust longitudinal control for a hypersonic glider with moving-mass actuation via L1-augmented dynamic inversion
Nonlinear geometric multivariable control for unmanned aircraft flight system
Numerical simulation of strut angle optimization for enhanced performance in DLR scramjet combustor
Active disturbance rejection control optimized via chaotic comprehensive learning pigeon-inspired optimization for flapping-wing aerial vehicle

Suggested Reading

On the active deformations of hybrid specimens
Aircraft Engineering and Aerospace Technology: An International Journal (September,2016)
The influence of specimen geometry upon weight change and shrinkage of air-dried mortar specimens
Magazine of Concrete Research (September,1971)
Influence of specimen geometry upon weight change and shrinkage of air-dried concrete specimens
Magazine of Concrete Research (June,1977)
Strain measurements on saturated concrete specimens
Magazine of Concrete Research (November,1963)
Design of geomembrane specimen for biaxial tensile testing
Geosynthetics International (October,2025)

Related Chapters

DURABILITY EVALUATION OF GFRP REINFORCED SPECIMENS USING ACOUSTIC EMISSION
Challenges of Concrete Construction: Volume 1, Composite Materials in Concrete Construction
INFLUENCE OF SPECIMEN SIZE ON MEASURED DIRECT TENSILE STRENGTH OF CONCRETE
Challenges of Concrete Construction: Volume 3, Repair, Rejuvenation and Enhancement of Concrete: Proceedings of the International Seminar held at the University of Dundee, Scotland, UK on 5–6 September 2002
INFLUENCE OF FIRE ON THE MECHANICAL BEHAVIOUR OF CONCRETE SPECIMENS
Challenges of Concrete Construction: Volume 3, Repair, Rejuvenation and Enhancement of Concrete: Proceedings of the International Seminar held at the University of Dundee, Scotland, UK on 5–6 September 2002

Recommended for you

These recommendations are informed by your reading behaviors and indicated interests.

Cited By

Google Scholar
This Feature Is Available To Subscribers Only

or Create an Account

Close Modal
Close Modal