Article navigation
Volume 6, Issue 11
1 November 1934
This article was originally published in
Aircraft Engineering
Aircraft Engineering Cover Image for Volume 6, Issue 11
Review Article| November 01 1934

The Strength of Tubular Struts: A Method of Calculating and Preparing Curves Suitable for Various Diameters and Gauges

Publisher: Emerald Publishing
Online ISSN: 2059-9366
Print ISSN: 0002-2667
© MCB UP Limited
1934
Aircraft Engineering (1934) 6 (11): 303–304.
https://doi.org/10.1108/eb029872

THE strength of tubular struts of uniform section and with pin‐jointed or rounded ends is calculated from, the formula

This content is only available via PDF.
© MCB UP Limited
1934
You do not currently have access to this content.
Don't already have an account? Register

Purchased this content as a guest? Enter your email address to restore access.

Pay-Per-View Access
$39.00
Rental
This article is also available for rental through DeepDyve. Read this now at DeepDyve
129 Views

New and popular articles

A SCADA-integrated predictive maintenance architecture for aircraft engines: comparative AI modelling and economic assessment
Condition monitoring for multi-phased mission system based on sequential local information increment
Wing–propeller interference
A cascaded asymmetric multilevel inverter for aircraft ground power unit: design and implementation

Suggested Reading

Use of vibrating wire strain gauges to measure loads in tubular steel props supporting deep retaining walls
Proceedings of the Institution of Civil Engineers - Geotechnical Engineering (January,1999)
The Strength of Tubular Struts: Charts for the Graphical Solution of a Common Design Problem
Aircraft Engineering (September,1954)
Biplane and Monoplane Compared: Full Details of the Two Blackburn Civil Aeroplanes Built to the Same Specification
Aircraft Engineering (November,1932)
Flying Laboratories: Two Machines Built in Germany for the D.V.L. Have Been Designed to Try Out Engines and Wings
Aircraft Engineering (January,1930)
Investigation on selective laser-melted AlSi10Mg micro-struts: influence of processing parameters on dimensional accuracy, molten pool morphology and microhardness
Rapid Prototyping Journal (July,2024)

Related Chapters

CHAPTER XI. COLUMNS AND LONG STRUTS.
THE DESIGN OF STRUCTURES.: A Practical Treatise on The Building of Bridges, Roofs, &c.
Measurements of Distributed Strain During Impact Pile Driving
Piling 2020: Proceedings of the Piling 2020 Conference
CHAPTER XI. THE DESIGN AND CONSTRUCTION OF STRUTS.
A practical treatise on bridge construction

Recommended for you

These recommendations are informed by your reading behaviors and indicated interests.

Cited By

Google Scholar
This Feature Is Available To Subscribers Only

or Create an Account

Close subscription notice
Close access options