Article navigation
Volume 70, Issue 5
1 October 1998
Aircraft Engineering and Aerospace Technology Cover Image for Volume 70, Issue 5
Editors
Phil Webb
Phil Webb
Search for other works by this author on:
This Site
PubMed
Google Scholar
Technical Paper| October 01 1998

First high‐velocity machining application in commercial helicopters

Tim Fox
Tim Fox is Chief Project Engineer at Bell Helicopter Textron, Mirabel, Quebec, Canada
Search for other works by this author on:
This Site
PubMed
Google Scholar
Author & Article Information
Publisher: Emerald Publishing
Online ISSN: 1758-4213
Print ISSN: 1748-8842
© MCB UP Limited
1998
Aircraft Engineering and Aerospace Technology: An International Journal (1998) 70 (5): 360–361.
https://doi.org/10.1108/00022669810236032

Describes the application of high‐velocity machining by Bell Helicopter Textron in order to produce parts below a certain wall thickness.

Keywords: Aerospace, Aircraft, Helicopters, Machining
© MCB UP Limited
1998
You do not currently have access to this content.
Don't already have an account? Register

Purchased this content as a guest? Enter your email address to restore access.

Pay-Per-View Access
$39.00
Rental
This article is also available for rental through DeepDyve. Read this now at DeepDyve
99 Views

New and popular articles

A fail-safe decision-support framework for onboard greywater reuse in commercial aircraft water systems
Dual-state estimation of electric vertical take-off and landing batteries: data-driven modeling and experimental verification
Development of 7XXX-Al series composite materials using high-speed mechanical alloying
Inverse finite element framework for aeroelastic integration of black-box subsystems under intellectual property constraints

Suggested Reading

High-speed machining revolutionises production at Boeing Helicopters
Aircraft Engineering and Aerospace Technology: An International Journal (October,1998)
Recuperated gas turbine aeroengines. Part III: engine concepts for reduced emissions, lower fuel consumption, and noise abatement
Aircraft Engineering and Aerospace Technology: An International Journal (July,2008)
Leading edge technology ensured with FMS
Aircraft Engineering and Aerospace Technology: An International Journal (October,1998)
Five operations into two
Aircraft Engineering and Aerospace Technology: An International Journal (December,1998)
Prototype and pre-production parts offered free with order
Aircraft Engineering and Aerospace Technology: An International Journal (February,2003)

Related Chapters

The Regulation of Space Tourism
Space Tourism: The Elusive Dream

Recommended for you

These recommendations are informed by your reading behaviors and indicated interests.

Cited By

Google Scholar
This Feature Is Available To Subscribers Only

or Create an Account

Close Modal
Close Modal