The purpose of this paper is to optimize the linear densities of polyester yarn and filament for inner layer and elastane for middle layer with cotton yarn outer layer in plain knitted plated structure for hot and dry environment clothing.
Three levels of polyester yarn linear densities (11.1, 8.4 and 5.6 Tex), filament linear densities (0.8, 1.55 and 2.3 Decitex) and elastane (0, 4 and 8 percent) with 14.75 Tex cotton yarn have been used to knit 15 single jersey plated fabrics based on Box and Benhens experimental design with same loop length. Three cotton–elastane core-spun fabrics were also produced. All the fabrics were analyzed for moisture and ergonomic comfort properties and wet fabric coefficient of friction.
The increase in elastane content and yarn linear density decreases water vapor and air permeability; the increase in filament linear density decreases wicking rate and water absorbency. The optimum solution is 5.55 Tex polyester yarn of 0.8 Decitex filament as inner layer and 14.75 Tex cotton yarn as outer layer which gives good heat and moisture transfer without stickiness.
The implication of this paper is to study thinner polyester, polypropylene and polyethylene fabrics with more micro pores as skin contact layer for quicker heat and moisture transfer.
Outward wickability of sweat from the skin is the prime requirement of all skin contact layer fabrics.
It shifts the social attitude of most comfortable fabric to polyester–cotton plated for hot and dry climate.
This paper employs a more practical method for the selection of fabric.
