Article navigation
Volume 3, Issue 1
1 January 1951
This article was originally published in
Scientific Lubrication
Scientific Lubrication Cover Image for Volume 3, Issue 1
Review Article| January 01 1951

FILTER TESTS with the aid of a DUST TUNNEL

;
W.S. James
Fram Corporation, U.S.A.
Search for other works by this author on:
This Site
PubMed
Google Scholar
Gratz Brown
Fram Corporation, U.S.A.
Search for other works by this author on:
This Site
PubMed
Google Scholar
Author & Article Information
Publisher: Emerald Publishing
Online ISSN: 2977-7224
Print ISSN: 0371-0947
© MCB UP Limited
1951
Scientific Lubrication (1951) 3 (1): 29.
https://doi.org/10.1108/eb053440

The Fram dust tunnel is a room 50 ft. long by 15 ft. wide, by 13 ft. high. A 200,000 cu. ft./min. blower is mounted slightly below floor level in one end of the room. It is driven by V‐belts from drums located transversely across the room, the drums being driven by the rear wheels of the car.

This content is only available via PDF.
© MCB UP Limited
1951
You do not currently have access to this content.
Don't already have an account? Register

Purchased this content as a guest? Enter your email address to restore access.

Pay-Per-View Access
$41.00
Rental
This article is also available for rental through DeepDyve. Read this now at DeepDyve
106 Views

New and popular articles

Study on surface integrity of IN718 cladding layer milled by micro texture tool
Study on friction reduction performance of MoS2/SiO2 hybrid nanofluids with minimum quantity injection lubrication during the drilling of Inconel 718
Computational hybrid framework for wear of polyurethane coated GFRP composites in offshore and onshore environments
Vibration-assisted interference fit of hole–shaft assemblies via micro-crawling feed

Suggested Reading

FRAM'S NEW SYSTEM TO RECLAIM OIL FROM WATER
Industrial Lubrication and Tribology (February,1972)
A fuzzy logic evolution of the functional resonance analysis method (FRAM) to assess risk in ground operation
Aircraft Engineering and Aerospace Technology: An International Journal (September,2023)
Fiber reinforced additive manufacturing: structurally motivated print orientation and sequential topology optimization of anisotropic material
Rapid Prototyping Journal (December,2023)
Additive manufacturing with fibre-reinforcement – design guidelines and investigation into the influence of infill patterns
Rapid Prototyping Journal (February,2022)
Resilience development: learnings for organisations from technical diving
Continuity & Resilience Review (December,2019)

Related Chapters

CHEMICAL CHARACTERIZATION AND USE OF KILN DUSTS OBTAINED IN TURKISH CEMENT PLANTS
Young Researchers' Forum: Proceedings of the International Conference held at the University of Dundee, Scotland, UK on 7 July 2005
Pyrometallurgical purification of brass smelter furnace flue dust
The exploitation of natural resources and the consequences: The proceedings of GREEN 3: the 3rd International Symposium on Geotechnics Related to the European Environment held in Berlin, Germany, June 2000
22. The behaviour of solid fission products in the AVR pebble-bed reactor
Nuclear Fuel Performance

Recommended for you

These recommendations are informed by your reading behaviors and indicated interests.

Cited By

Google Scholar
This Feature Is Available To Subscribers Only

or Create an Account

Close Modal
Close Modal