Investigation into the relationship between tool‐wear and cutting environments when milling an austenitic stainless steel and En32 low carbon steel

Cutting fluids despite playing an important role in metal cutting have considerable environmental impact. Inert gaseous metal cutting environments were investigated with the aim of removing soluble oil cutting fluids from metal cutting operations.Design/methodology/approach – Industrially reproducible cutting tests were devised, where an austenitic stainless steel and En32 low carbon steel material was milled in a range of different cutting environments. Tool life was measured for tests carried out in a number of gaseous environments and results were then compared with test results from conventional flood cutting environments.Findings – Low oxygen gaseous environments were compared with conventional cutting environments and a considerable flank wear reduction has been recorded using CVD coated tooling. Additionally flood coolant environments have been seen to promote chemical wear after the initial breakdown of coatings leading to rapid flank wear during milling of both En32 and austenitic stainless steel.Research limitations/implications – Only a limited number of work/tool material combinations have been investigated. A more detailed and exhaustive investigation is required to ascertain the scope of the improvements for a range of tool work combinations. This will assist in understanding the underlying reasoning for the tool life enhancement reported.Practical implications – All experimentation carried out is industrially reproducible. This work, therefore, proposes an environmentally clean alternative to the use of emulsified oils in metal cutting operations in order to exploit cost savings and improved operator working environments.Originality/value – Distinct operational performance improvements have been demonstrated in the form of extended tool life for metal cutting operations performed in a non‐polluting cutting environment. These findings could herald widespread advantages within the metal cutting community.