... paper fixed on the hardened steel disk with the help of a cantilever mechanism. The pin collet is mounted in a steel holder in the wear machine so that the collet is held firmly perpendicular to the flat surface of the rotating counter disk. Analysis of variance Taguchi Wear behaviour...

... The present work is accomplished to examine the wear behavior of RZ5-TiC composites. The coefficient of friction and weight loss are used as the response variable. The wear process parameters are optimized to minimize response variable. Optimization Analysis of variance Metal matrix composite Abrasive...

... experienced. After the experiments were conducted and the S/N ratio determined for each test case, a mean S/N ratio value is calculated for each design factor level. This data was statistically analysed using analysis of variance (ANOVA) technique. The goal is to find control factor settings that generate...

... technique. A L27 Orthogonal array is selected for analysis of the data. Influence of applied load, sliding speed and weight percentage of reinforcements on wear rate as well as the coefficient of friction during wearing process is studied using analysis of variance technique and regression equations...

...‐coated carbide drills. The settings of drilling parameters were determined by using Taguchi experimental design method. An orthogonal array, the signal‐to‐noise (S/N) ratio, and the analysis of variance (ANOVA) were employed to analyze the effect of drilling parameters. The objective...

... of cutting parameters on surface roughness in turning of glass‐fibre‐reinforced plastics (GFRPs). A plan of experiments was performed on controlled machining with cutting parameters prefixed in workpiece. A statistical technique, using orthogonal arrays and analysis of variance, has been employed...