... Emerald Publishing Limited 2026 Emerald Publishing Limited Licensed re-use rights only Wear evolution Fretting Sliding Worn surface Dry friction National Natural Science Foundation of China, 52475211 Special project for science and technology development of HBSTD...

... on the films were investigated. In addition, tribological properties of Ni/CNTs films sliding against GCr15 steel were evaluated under dry friction at sliding speeds varied from 0.042 to 0.2 m/s. Findings The thickness of the Ni/CNTs films was approximately 48 µm. The adhesion strength of the Ni/CNTs film...

... of Si₃N₄ ball/block pair were investigated. Design/methodology/approach Under dry friction conditions, the surface profiles of Si₃N₄ ceramic blocks at different test angles were observed by the Taylor roughness meter. Then, the reciprocating sliding friction test method was used...

... effects of PEEK and its composite cages on full ceramic ball bearings. Design/methodology/approach In this study, 6206 full ceramic ball bearings with different cage types were tested using a bearing life tester under dry friction conditions. Thermal characteristics under various working conditions...

... with different amplitudes, ranging from 0.05 to 0.3 mm, and frequencies, ranging from 5 to 17.5, are fabricated using nanosecond pulsed laser equipment. The friction experiments and the finite element analysis method are combined to investigate the tribological properties, under dry friction conditions...

...Yue Wang; Longqing Zou; Hailong Fu; Congcong Huang; Jiaqi Liu Purpose Wear failure happens frequently in rubber seal of high-speed rotating shaft because of the dry friction. Some traditional lubrication methods are not effective because of the restrictions on the relative high speed, temperature...

... resistance. Deep drawing Dry forming ta-C coating Direct laser interference patterning Dry friction DLC coating German Federal and State Governments to promote top-level research at German universities F-003661-553-71A-1132104 The German Research Foundation (DFG) is greatly...

...Guotao Zhang; Yanguo Yin; Ting Xie; Dan Li; Ming Xu; Congmin Li Purpose This paper aims to obtain high mechanical and good tribological properties of epoxy resin-based coatings under dry friction conditions. Design/methodology/approach Bonded solid lubricant coatings containing Kevlar fibres...

... = coefficient of friction. SEM Wear resistance AlCrN Dry friction PVD coating © Emerald Publishing Limited 2017 Emerald Publishing Limited Licensed re-use rights only 11 05 2016 16 08 2016 12 09 2016 Vijayasarathi Prabakaran can be contacted...

... prepared small-scale materials and simple structure components. It is necessary to prepare and select the wear-resistant material to replace existing materials to design a sliding shoe under specific testing conditions. Wear resistance Wear mechanism Sliding Dry friction In this study...

... Wear Journal bearings Aluminium‐based alloys Dry friction Alloys Mostly copper‐, aluminium‐, zinc‐, lead‐ and tin‐based alloys are used in journal bearings. Recently, aluminium can be used in same load ranges with tin‐bronzes containing white metal and lead. Al‐based bearings have higher...