... porosity, making them ideal for demanding industrial applications. The characterization of as sprayed specimen was done with the help of XRD, SEM/ EDS analyses. Further, the physical properties such as porosity and surface roughness of as-sprayed coating have also been reported. Table 5 Various...

... 06 12 2024 20 04 2025 29 04 2025 © 2025 Emerald Publishing Limited 2025 Emerald Publishing Limited Licensed re-use rights only Magnesium alloy Squeeze casting Wear and friction behaviour Solid lubrication SEM The current scenario in aerospace and automobile...

... field emission scanning electron microscope (SEM) is used to detect the subsurface of the material and the side of the milling groove, as shown in Figure 3(f) . The Taguchi experimental design (DOE) test method is widely used in academic and industrial fields to determine the most effective...

... 18 02 2024 18 03 2024 © Emerald Publishing Limited 2024 Emerald Publishing Limited Licensed re-use rights only Wear Friction Molybdenum disulfide grease Break-in period ZDDP Variable loads AES SEM EDS Design of experiment (DOE) Tribology is the study...

... physical or chemical synergies among lube oils, additives and ball surface using SEM. The molecule structures of TMPTO based lube oils were confirmed using Fourier transform infrared spectroscopy (FTIR). Findings The wear preventive and extreme pressure characteristics of different TMPTO based samples...

... 2020 03 01 2021 18 02 2021 21 03 2021 22 03 2021 22 03 2021 © Emerald Publishing Limited 2021 Emerald Publishing Limited Licensed re-use rights only SEM Roughness Microstructure Anti-wear and friction-reducing Dry sliding tests Friction noise...

... in distilled water for obtaining slurry. The morphology of silica sand particles is shown by SEM micrographs in Figure 2(a-b) . Figure 2 SEM micrograph of (a) 300 µm and (b) 600 µm silica sand particles To analyze the effects of various parameters on the slurry erosion behavior, Taguchi...

... grade E52100. Findings The results indicated that ball-milled MoS₂ grease tests showed reduction in wear and friction under all conditions, especially spectrum or actual loading. Unmilled MoS₂ powder exhibited worse wear outcomes than the milled one. The SEM and AES analyses...

... outcomes and signal-to-noise (S/N) ratio analysis. Findings It is observed that coefficient of friction was greatly influenced by speed, and weight loss of piston ring and cylinder liner was greatly influenced by load. The surface morphology by SEM (scanning electron microscopy) analysis was used...

... steel was characterized using the X-ray diffraction analysis (XRD) technique with the Cu Ka radiation. The SEM is used to key out the wearer debris and analyze the oxide layer formed during the wear test on the coated surface. Table II Abrasion testing machine parameters Substrate ML...

... condition. Findings – The wear rate decreases with the increase of SiCp into A356-3Gr composites. The composite containing A356-9SiCp-3Gr had better hardness and good wear resistance compared to the base alloy. Scanning electron microscope (SEM) and electro dispersive spectrometry (EDS) images were...