Keywords: adhesive
Close
Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Journal Articles
Journal Articles
Emerging Materials Research (2026) 15 (1): 21–33.
Published: 02 December 2025
... 09 2025 © 2025 Emerald Publishing Limited 2025 Emerald Publishing Limited Licensed re-use rights only abaca fiber adhesive bio-composites low-velocity impact mechanical properties natural fibers thermal conductivity UN SDG 9: Industry, innovation and infrastructure UN SDG 12...
Journal Articles
Emerging Materials Research (2025) 14 (4): 361–371.
Published: 21 November 2025
.... These findings highlight the potential of recycled PETs as a sustainable filler to improve composite properties while addressing waste management challenges. © 2025 Emerald Publishing Limited 2025 Emerald Publishing Limited Licensed re-use rights only adhesive composite materials dynamic properties...
Journal Articles
Emerging Materials Research (2021) 10 (3): 295–299.
Published: 08 July 2021
... by the compression-molding process. [K]4 composite laminates were obtained by curing Kevlar/epoxy laminates under 100°C and 7 bar pressure for 180 min. Then, samples of size 100 × 100 mm were cut from the plates with a water jet. The cut specimens were bound together with two-component adhesive...
Journal Articles
Emerging Materials Research (2020) 9 (4): 1113–1120.
Published: 05 October 2020
... by sequentially fracturing the adhesive interfaces from the top tube to the back tubes. In each bonding interface fracture, a certain amount of the impact energy was reduced. These gradually broken adhesive bonds and subsequent movement of the coaxial tubes were increased pedestrian safety by producing fewer...
Journal Articles
Emerging Materials Research (2019) 8 (4): 668–672.
Published: 11 September 2019
... of cracking resulting from wear on the tool. adhesive design manufacturing The contact between the cutting tool and workpiece causes high deformation on the parts over time, and high temperatures occur between the contact surfaces due to friction. Therefore, the material properties of the parts...
Journal Articles
Emerging Materials Research (2016) 5 (2): 284–290.
Published: 01 December 2016
... and loading cycle contact wear. The results showed that the use of solid lubricant MoS2T coating is capable of total prevention of generation of stainless steel particles due to adhesive wear. This study also shows that no stainless steel particles were found on the carbon tape, suggesting...

or Create an Account

Close Modal
Close Modal