Synopsis
This article describes the “Benoto” system for sinking 3-foot-3-inch-diameter steel cylinders through water-bearing gravel and silt to bedrock at a depth of approximately 140 feet below ground surface level.
Sinking of a cylinder is effected under its own weight by grabbing-out the contained material while, at the same time, the cylinder is continually rotated backwards and forwards about its vertical axis through an angle of 8 degrees.
When a cylinder is sunk to sound rock, it is filled with concrete thus forming a pile which is to carry a load of approximately 450 tons, including its own weight, together with frictionally applied load from settlement of the surrounding ground.
The specialized plant used in sinking is a “Benoto” grab and a “Benoto” tubing machine. The grab is a 35-inch-diameter, single rope type, weighing 1,984 lb. and operated by a crane made for the purpose. The tubing machine consists of a double acting hydraulic jack operated by a hydraulic pump. The jack oscillates a 21-foot-6¼-inch-long lever arm which is clamped to the cylinder.
Cet article décrit le système “Benoto” pour enfoncer des cylindres en acier de 3 pieds 3 pouces de diamètre à travers du gravier aquifère et du limon jusqu'aux roches de fond à une profondeur d'environ 140 pieds au-dessous du niveau du sol.
L'enfoncement d'un cylindre s'effectue par son propre poids tandis qu'on en arrache les matériaux qu'il contient et qu'en même temps on le fait continuellement basculer d'arrière en avant sur son axe vertical selon un angle de 8 degrés.
Quand un cylindre est enfoncé jusqu'aux roches fermes, on le remplit de béon et il forme ainsi un pieu qui doit supporter une charge d'environ 450 tonnes, son propre poids inclus, ainsi que la charge qui s'applique par friction provenant de l'affaissement du sol environnant.
La machinerie spécialisée employée dans l'opération d'enfoncement est une benne-drague “Benoto” et une machine à tuyautage “Benoto.” La drague, qui est du type à un seul cable, a 35 pouces de diamètre, pèse 1,984 livres (anglaises). Une grue spéciale la fait fonctionner. La machine à tuyautage se compose d'un vérin hydraulique à double effet actionné par une pompe hydraulique. Le véin fait osciller un levier de 21 pieds 6 pouces qui est agrafé au cylindre.
