... energy conservation materials technology waste management & disposal Cement and lime stabilisation are widely used to improve the engineering properties of soft soils (Ardah et al., 2017 ; Boardman et al., 2001). Approximately 1−1.2 t of carbon dioxide (CO₂...

... decrease in strength after peak than the non-treated specimens. This effect is emphasised in Figure 3 with the representation of the brittleness index (I_{b), described by (Venda Oliveira and Neves, 2019 ; Venda Oliveira et al., 2016b) geotechnical engineering materials technology}...

...-cement–soil mixtures is possible, it requires strict construction control and adherence to very tight tolerances, which makes it impractical for most highway construction projects. materials technology roads & highways strength & testing of materials 19 12 2018 22 07 2019...

... on systematic tests on hydrated grouts. Furthermore, evaluation tests to determine the cement content of grouted soil specimens were carried out and are discussed in this paper. 03 03 2019 19 07 2019 ICE Publishing: All rights reserved 2019 granular materials grouting materials...

..., the specimen was subjected to applications and removals of sticky tape to remove debris and particles damaged during fracturing. The peeled specimen surface was vacuum coated with gold to make it electrically conductive to prevent charge build up on the specimen. granular materials materials...

... containing calcium sulfate and potassium (K₂Ca₂ (SO_{4)3) was not observed. 01 03 2018 22 04 2018 ICE Publishing: All rights reserved 2018 buildings, structures & design materials technology strength & testing of materials In search}...

... sections improved the performance of the pavement section when compared with the unstabilised section. 25 04 2017 22 03 2018 ICE Publishing: All rights reserved 2018 geosynthetic applications materials technology pavement design With increased material costs and reduced...

... originally perceived in the present research to be directly associated with the porosity/cement index. This broadens the applicability of such index, demonstrating that it controls not only the strength but also endurance performance of sand–cement blends. granular materials materials technology roads...

..., whereas the surcharge preloaded samples showed a more dispersed structure. ICE Publishing: All rights reserved 2016 geotechnical engineering materials technology strength & testing of materials 06 07 2015 17 03 2016 As the demand for land increases for urban...

..., shrinkage limit and plasticity index with calculated percentage of lime precipitation occurring on sequential mixing of CaCl₂ and NaOH solutions with expansive soil 13 8 2013 13 8 2013 ICE Publishing: All rights reserved 2014 geotechnical engineering materials...

... Publishing: All rights reserved 2014 geotechnical engineering materials technology pavement design Lime and cement are widely used calcium-based stabilisers for treating expansive soils (Hausmann, 1990). Addition of lime or cement to expansive soils improves the workability, reduces swell...

... ICE Publishing: All rights reserved 2013 materials technology strength and testing of materials C cement content (expressed in relation to mass of dry soil) C_iv volumetric cement content (expressed in relation to the total specimen volume...

...°. 28 7 2011 24 12 2010 ICE Publishing: All rights reserved 2013 geotechnical engineering materials technology strength and testing of materials Creep is the viscoelastic response to a constant deviator stress and is characterised by primary, secondary and tertiary...

... combination of cement content and ash content. Thermogravimetric (TG) analysis showed that the cementitious products of the blended cement-admixed clay samples are practically the same as long as the w_c/C is the same. ICE Publishing: All rights reserved 2012 materials...

... rights reserved 2012 materials technology strength and testing of materials Soil stabilisation/mixing is a form of ground improvement in which cementitious and/or pozzolanic materials are introduced to a soil, with the goal of improving strength and deformation characteristics (e.g...

... materials technology strength and testing of materials B width of the footing L length of reinforcement N number of layers of reinforcement p vertical spacing between reinforcement layers s settlement of model footing z...

... materials technology quality control The site under investigation is located on the east peripheral road of the Tokyo International airport. The revetment near the site was raised by 4 m corresponding to the construction project for the C-runway beyond the waste disposal facilities with double...

... and after preloading 15 1 2010 26 6 2009 ICE Publishing: All rights reserved 2011 materials technology strength and testing of materials (1) %   reduction   in   settlement   =   − 0.05 r 3 + 1.51 r 2 − 14.46 r + 101.82...

... diameter mould. Taek et al. (2002) measured the compaction strain of EPS beads; they found that it was 6·7 to 9%, depending on the compaction energy, regardless of the ratio of mixed beads to sand. © 2010 Thomas Telford Ltd 2010 embankments environment materials technology...