Electrodeposition preparation of Ni–Fe alloy foil Available to Purchase

In this study, the electrodeposition of a nickel (Ni)–iron (Fe) alloy foil was thoroughly investigated. Linear potential sweep and cyclic voltammetry method were used to investigate the electrochemical behaviour of the nickel–iron alloy foil. In addition, single-factor experimental studies were combined with an orthogonal test analysis to obtain optimum experimental conditions. Scanning electron microscopy and X-ray diffraction were used to investigate the surface morphology and the crystalline structure of the nickel–iron alloy foil. The obtained nickel–iron alloy foil was a face-centred cubic crystal with a bright and smooth surface, in which no pinholes or cracks appeared. The average hardness value, electrical resistivity, maximum permeability, saturation magnetic flux density (B _s) and residual magnetism (B _r) of the obtained nickel–iron foil were 280 HV, 38–41 μΩ cm, 0·172 mH/m, 1·093 T and 0·0088 T, respectively. Lastly, the obtained nickel–iron foil displayed good soft magnetic properties, toughness and low residual stress.