Skip to Main Content
Article navigation
  •  
  •  

After contracting with a communications carrier, such as Telenet or Tymenet, and a database service, such as BRS or Dialog, setting up the Hayes Smartcom II to aid in database searching with the M300 or any other IBM PC can be a frustrating experience, especially if you rely on the manual provided by the company. Though Smartcom II will do a lot more than covered in this introduction, following the steps outlined here will provide a practical way to begin using it.

This content is only available via PDF.
You do not currently have access to this content.
Don't already have an account? Register

Purchased this content as a guest? Enter your email address to restore access.

Please enter valid email address.
Email address must be 94 characters or fewer.
Pay-Per-View Access
$39.00
Rental

or Create an Account

Close Modal
Close Modal