To determine the feasibility of sealing and finishing conformal cooling/heating channels in profiled edge laminae (PEL) rapid tooling (RT) using abrasive flow machining (AFM).
Sample PEL tools constructed of both aluminum and steel were designed and assembled for finishing by AFM. A simple design of experiments approach was utilized. Output parameters of interest included the material removal, surface roughness improvement and, most importantly, the ability to withstand a pressurized oil leak test.
AFM significantly improved the finish in the channels for aluminum and steel PEL tooling. Leak testing found that AFM also improved the sealing of both stacks at static pressures up to 690 kPa. The steel tooling appeared to benefit more from the AFM process. It has been postulated that the primary cause of the sealing is the plastic deformation of workpiece material in the plowing mode.
The conformal channels studied had a simple cross‐sectional geometry and straight runs. The PEL tools were only made of two materials. However, the research results show great promise for large RT, including thermoforming and composite forming molds where temperature control is a critical issue.
The ability to seal the interfaces between individual laminae expands the potential application of AFM tremendously. AFM also has the potential to finish a wide range of internal passages in a variety of RT.
AFM has been previously used for finishing stereolithography prototypes. This is the first known attempt to seal and finish channels in laminated RT using AFM.
