– This paper aims to present the development of an electrospinning-based rapid prototyping (ESRP) technique for the fabrication of patterned scaffolds from fine fiber.
– This ESRP technique unifies rapid prototyping (RP) and electrospinning to obtain the ability of RP to create a controllable pattern and of electrospinning to create a continuous fine fiber. The technique follows RP process of fused deposition modeling, but instead of using extrusion process for fiber creation, electrospinning is applied to generate a continuous fiber from a liquid solution. A machine prototype has been constructed and used in the experiments to evaluate the technique.
– Three different lay-down patterns: 0°/90°, 45°/135° and 45° twists were used in the experiments. According to the experimental results, stacks of patterned layers could be created with the ESRP technique, and the fabrication process was repeatable and reproducible. However, the existing machine vibration influenced the fiber size and the ability to control straightness and gap size. Also, incomplete solidification of the fibers prior to being deposited obstructed the control of layer thickness. Improvement on vibration suppression and fiber solidification will strengthen the capability of this ESRP technique.
– This research is currently limited to the introduction of the ESRP technique, to the development of the machine prototype, to the demonstration of its capability and to the evaluation of the structural properties of the fabricated patterned scaffolds. Further studies are required for better control of the patterned scaffolds and for investigation of mechanical and biological properties.
– This unification of the two processes allows not only the fabrication of controllable patterned scaffolds but also the fabrication of both woven and non-woven layers of fibers to be done on one machine.
