The purpose of this study is to investigate the manufacturability of Fe-3Si lattice structures and the resulting mechanical properties. This study could lead to the successful processing of squirrel cage conductors (a lattice structure by design) of an induction motor by additive manufacturing in the future.
The compression behaviour of two lattice structures where struts are arranged in a face-centred cubic position and vertical edges (FCCZ), and struts are placed at body-centred cubic (BCC) positions, prepared by laser powder bed fusion (LPBF), is explored. The experimental investigations are supported by finite element method (FEM) simulations.
The FCCZ lattice structure presents a peak in the stress-strain curve, whereas the BCC lattice structure manifests a plateau. The vertical struts aligned along the compression direction lead to a significant increase in the load-carrying ability of FCCZ lattice structures compared to BCC lattice structures. This results in a peak in the stress-strain curve. However, the BCC lattice structure presents the bending of struts with diagonal struts carrying the major loads with struts near the faceplate receiving the least load. A high concentration of geometrically necessary dislocations (GNDs) near the grain boundaries along cell formation is observed in the microstructure.
To the best of the authors’ knowledge, this is the first study on additive manufacturing of Fe-3Si lattice structures. Currently, there are no investigations in the literature on the manufacturability and mechanical properties of Fe-3Si lattice structures.
