... Publishing Limited 2025 Emerald Publishing Limited Licensed re-use rights only Optimization Fused deposition modelling Rapid prototyping Fabrication Taguchi methods Three-dimensional (3D) printing, also known as rapid prototyping (RP), is a manufacturing technology that creates parts...

... performance for a given design. Design/methodology/approach The Taguchi method was used to shortlist a set of 18 different combinations of build parameters and testing conditions. Accordingly, 18 specimens were 3D printed using those combinations and put through a series of uniaxial tensions tests...

... to print a PEEK results in low strength and crystallinity. This study aims to use the Taguchi method to optimize the printing factors to obtain the highest tensile strength of the printed PEEK object. The annealing effect on printed PEEK object and crystallinity are also investigated. Design/methodology...

... 2020 23 10 2020 © Emerald Publishing Limited 2020 Emerald Publishing Limited Licensed re-use rights only ANOVA Optimization Additive manufacturing S/N ratio 3D printing Compressive strength Porosity Taguchi methods Porous bone scaffold Artificially developed...

...Sakthivel Murugan R.; Vinodh S. Purpose This paper aims to optimize the process parameters of the fused deposition modelling (FDM) process using the Grey-based Taguchi method and the results to be verified based on a technique for order preference by similarity to ideal solution (TOPSIS...

...Che Chung Wang; Ta‐Wei Lin; Shr‐Shiung Hu Purpose The following research seeks to focus on optimizing the fused deposition modeling (FDM) process of RP systems. Design/methodology/approach Early stages of this study are based on the Taguchi method in establishing rapid prototyping building...

... experimental sets (Prasad et al., 2005). This study presents the optimization of dimensional accuracy of wax patterns produced by RTV silicone rubber mold. Three factors with four levels for each factor were considered. These factors and their levels are shown in Table I . The Taguchi method...

...) represents quality characteristics for the observed data in the Taguchi design of experiments. In the case of surface roughness, lower values are desirable. These S/N ratios in the Taguchi method are called as the‐lower‐the better characteristics and are defined as follows: Equation 4...

... of a specially developed iron‐based powder mixture (Fe, Ni, Cu and Fe₃P) has been tested on an SLS machine. © Emerald Group Publishing Limited 2005 Lasers Sintering Iron Rapid prototypes Taguchi methods In the present paper, ongoing development of a ferro‐based powder (Kruth...

... tooling process, HLM. This unique methodology would reduce the cost and time to make molds and dies that are used in batch production. Kim and Rhee (2002) , developed a fuzzy controller based on Taguchi methods to stabilize the arc during CO₂ welding process. Statistical experiments...

... is to investigate the powder material and to optimize the process parameters for Zcorp 402 3DP rapid fabricator. Taguchi's method was employed to investigate the possible process parameters including binder setting saturation value (shell & core), layer thickness, and location of made‐up parts. The experimental...