Article navigation
Volume 32, Issue 9
1 September 1960
This article was originally published in
Aircraft Engineering
Aircraft Engineering Cover Image for Volume 32, Issue 9
Review Article| September 01 1960

Photoelastic Measurement of Surface Strain: Investigation of a Direct Method Using an Optically Sensitive Material Bonded to the Metal Component

Publisher: Emerald Publishing
Online ISSN: 2059-9366
Print ISSN: 0002-2667
© MCB UP Limited
1960
Aircraft Engineering (1960) 32 (9): 261–270.
https://doi.org/10.1108/eb033298

Tapered and Parallel Shank Specimens Tapered and parallel shank specimens were loaded in increments of 200 lb. up to about 1,300 lb., generally the maximum for both types.

This content is only available via PDF.
© MCB UP Limited
1960
You do not currently have access to this content.
Don't already have an account? Register

Purchased this content as a guest? Enter your email address to restore access.

Pay-Per-View Access
$39.00
Rental
This article is also available for rental through DeepDyve. Read this now at DeepDyve
104 Views

New and popular articles

Kriging-assisted full-envelope ADRC gain scheduling for fixed-wing UAVs
An AHP-fuzzy FMEA and bow-tie barrier approach for maintenance risk assessment of outdoor-parked general aviation aircraft
Bottom-up computational design of a hybrid tricopter agricultural spray UAV: propeller, nozzle, tank and airframe CFD optimization
Agricultural waste to aircraft interiors: mechanical, dynamic mechanical and durability characteristics of rice husk-reinforced composites based on waste polyethylene terephthalate

Suggested Reading

Photoelastic Measurement of Surface Strain: Investigation of a Direct Method Using an Optically Sensitive Material Bonded to the Metal Component
Aircraft Engineering (August,1960)
A wavelength calibration method for photoelastic-modulated Fourier transform spectrometers
Sensor Review (June,2022)
Photoelastic and photographic study of a granular material
Geotechnique (January,2011)
TEACHING TOPICS: A Photoelastic Bench Demonstration Model
Technical Education and Industrial Training (June,1960)
A new photoelastic material for use in problems concerning reinforced concrete
Magazine of Concrete Research (November,1963)

Related Chapters

A discrete numerical model for granular assemblies
The Essence of Geotechnical Engineering: 60 years of Géotechnique
STRESS DISTRIBUTIONS IN THE ANCHORAGE ZONES OF POST-TENSIONED BEAMS
‘Measurements in Civil Engineering’
40 Use of structural models in developing pressure vessel design
PRESTRESSED CONCRETE PRESSURE VESSELS

Recommended for you

These recommendations are informed by your reading behaviors and indicated interests.

Cited By

Google Scholar
This Feature Is Available To Subscribers Only

or Create an Account

Close subscription notice
Close access options