Flexible Circuit Materials for Use as Interconnections in High Speed Digital Systems

The increasing use of high switching speed systems in both microwave electronics and high speed logic devices has created the need for printed circuit boards which are based on low dielectric constant and low loss materials. In addition, these circuit materials must be capable of withstanding elevated temperatures typical of hostile service environments and of board fabrication processes. Such low dielectric constant rigid boards are commercially available from a few sources. However, there is a growing demand for low dielectric constant flexible printed circuit boards for interconnecting rigid boards or in rigid/flex applications where high speed, fast rise times, controlled impedance and low crosstalk are important. A new family of thin laminates which are suitable for fabrication of flexible low dielectric constant printed circuit boards have been developed by Rogers Corporation. These circuit materials are called ROhyphen;2500 laminates and offer flexible interconnections in high speed electronic systems. RO‐2500 circuit materials are based on microglass reinforced fluorocarbon composites and have a typical dielectric constant of 25. The transmission line properties of these materials have been evaluated by the IPC‐FC‐201 test method. The results indicated that these circuit materials improve the propagation velocity by about 10% and the rise time by about 30% when compared with the same geometry, polyimide film based, flexible PCs in stripline constructions. Also, dimensional stability of these laminates after etch and heat ageing is improved over that of the standard flex circuit materials based on polyimide film. RO‐2500 laminate properties have been evaluated by the IPC‐TM‐650 test methods, which are widely accepted by the flexible PCB industry.