Skip to Main Content
Article navigation
Volume 1, Issue 5
1 May 1949
This article was originally published in
Scientific Lubrication
Scientific Lubrication Cover Image for Volume 1, Issue 5
Review Article| May 01 1949

Soluble cutting oils

H.M. HARMAN
H.M. HARMAN
Search for other works by this author on:
This Site
PubMed
Google Scholar
Author & Article Information
Publisher: Emerald Publishing
Online ISSN: 2977-7224
Print ISSN: 0371-0947
© MCB UP Limited
1949
Scientific Lubrication (1949) 1 (5): 15–16.
https://doi.org/10.1108/eb052010

MOST of the heat generated in cutting is caused by the chips breaking away from the stock and it is therefore necessary to maintain the cutting coolant at a constant temperature. Reduced coolant temperature will also prolong tool life. In addition, if temperatures are excessive, oil will be lost in smoke which is both wasteful and objectionable.

This content is only available via PDF.
© MCB UP Limited
1949
You do not currently have access to this content.
Don't already have an account? Register

Purchased this content as a guest? Enter your email address to restore access.

Please enter valid email address.
Email address must be 94 characters or fewer.
Pay-Per-View Access
$41.00
Rental
This article is also available for rental through DeepDyve. Read this now at DeepDyve
112 Views
View Metrics
Analysis of temperature and vibration characteristics of ball-defect bearing under different oil–gas lubrication conditions
A lightweight and efficient deep learning model for wear particle classification in lubricating oil
Simulation and experimental verification of vibration signals for bearing faults in the framework of digital twin
Tribological improvement of magnesium alloy using solid lubricant with cerium oxide catalysis under heating treatment conditions

Suggested Reading

An investigation of organic mixed coolant (Palm Olein) for green machining
Industrial Lubrication and Tribology (March,2014)
Zyklomat Coolant Glarifiers
Industrial Lubrication and Tribology (December,1968)
FILTRATION OF HOT MILL COOLANTS: for Aluminium Rolling Mills
Anti-Corrosion Manual (May,1971)
ECONOMICS OF SOLUBLE CUTTING FLUIDS
Industrial Lubrication and Tribology (September,1970)
New Developments in Soluble Oil Manufacture
Scientific Lubrication (November,1959)

Related Chapters

20. Reanalysis of oxide solubility data
Water chemistry of nuclear reactor systems 5
Paper 38. Corrosion product solubility in the PWR primary coolant
WATER CHEMISTRY OF NUCLEAR REACTOR SYSTEMS 4
10. Significance of the chemical and volume control system in corrosion product transport to PWR coolants
Water chemistry of nuclear reactor systems 5

Recommended for you

These recommendations are informed by your reading behaviors and indicated interests.

Cited By

Google Scholar
This Feature Is Available To Subscribers Only

or Create an Account

Close Modal
Close Modal