The hydrodynamic characteristics of liquid film for bearings, especially water-lubricated bearings with a large length-to-diameter ratio, affect the dynamics behavior of rotor bearing systems. The purpose of this study is to carry out theoretical analysis and experiments to determine the hydrodynamic characteristics of water-lubricated journal bearings.
The finite difference method is adopted for the simulation of the characteristics of water-lubricated bearings. The comparison results between water-lubricated bearings with and without grooves, as well as with and without the consideration of the effects of rubber deformation, are presented. The test bearings, test bench, and monitoring system, especially the force exciter for the bearing experiment, are presented. Dynamic coefficient identification verification experiments were performed in different working situations. The obtained results include the calibration of magnetic force, two kinds of excitation, vibration data of the rotor system and dynamic coefficients.
The theoretical results demonstrate that the hydrodynamic effect was obvious when the speed was increased and that the water film had improved capability at a working speed of 1800 rpm. The identification results reveal the lubrication situation of the test bearing under low-speed and high-load conditions. Moreover, it was found that the liquid film was not continuous at low speeds.
The theoretical results can lead to the enhancement of the design level of water-lubricated rubber journal bearings with a large aspect ratio. The experimental results can lead to the improvement of the dynamic behavior design of rotor systems supported using water-lubricated bearings with a large length-to-diameter ratio.
