Ultimate limit state design using an advanced ‘Brick' model in the finite-element method Available to Purchase

The increasing use of the finite-element method in geotechnical design has raised the question of the compliance of this design approach with Eurocode requirements for the ultimate limit state conditions, especially when a more complex soil constitutive model has been used. Past authors have identified several important issues relating to the application of the finite-element method in ultimate limit state design, including the effects of initial stresses, effects of stress history, choice of soil model, significance of the failure of structural member and the timing when the partial factor of safety is applied during the design assessment. In this paper, an advanced ‘Brick' soil model has been used to demonstrate its application in the design of different geotechnical structures and the effects of the design assumptions used in the design of these structures. The paper also demonstrates the versatility of the Brick soil model in the derivation of the new set of input parameters when the necessary partial factor is applied to the strength of the soil as required in the Eurocode design approach.