Stereolithography (SLA) is a broadly used technology in the field of rapid prototyping. One of the disadvantages of SLA is poor mechanical properties of its products. To approach the mechanical properties of original part, the mechanical properties of SLA part, such as tensile strength, should be optimized. In this process, there are many parameters that affect the tensile strength of parts. However, the “layer thickness”, “fabrication orientation” and “post curing time” are the most significant ones. Hence, the purpose of this study is to investigate the influence of these parameters on tensile strength of SLA parts.
According to the obtained results from experiments based on the “full factorial” method, an empirical equation was developed for the tensile strength in terms of the effective parameters by using regression analysis. Considering this empirical equation, the process parameters were optimized to maximize the tensile strength by using genetic algorithm. Finally, the tensile tests of the specimens were simulated via the general-purpose finite element package of ABAQUS.
The outputs of the numerical simulations were in good agreement with experimental results. Both experimental and numerical results show that the increase of layer thickness and the decrease in post curing time increase the tensile strength. Furthermore, the tensile strength of parts produced in vertical orientation is higher than that of parts produced in horizontal orientation.
This is a complete study about the tensile strength of the SLA parts from experimental and analytical viewpoints.
