The aim of this study is to investigate the printing parameters of fused deposition modeling (FDM), a material extrusion-based method, and to examine the mechanical and thermal properties of their polylactic acid (PLA) components reinforced with copper, bronze, and carbon fiber micro particles.
Tensile test samples were created by extruding composite filament materials using FDM-based 3D printer. Taguchi method was used to design experiments where layer thickness, infill density, and nozzle temperature were the printing variables. Analysis of variance (ANOVA) was applied to determine the effect of these variables on tensile strength.
The results of this study showed that the reinforcement of metal particles in PLA material reduces strength and increases elongation. The highest tensile strength was obtained when the layer thickness, infill density, and nozzle temperature were set to 100 µm, 60%, and 230 °C, respectively. As a result of thermal analysis, cooper-PLA showed the highest thermal resistance among metal-based PLA samples.
It is very important to examine the mechanical and thermal quality of parts fabricated in FDM with metal-PLA composites. In the literature, the mechanical properties of metal-reinforced composite PLA parts have been examined using different factors and levels. However, the fabrication of parts using the FDM method with four different metal-added PLA materials has not been examined before. Another unique aspect of the study is that both mechanical and thermal properties of composite materials will be examined.
