Evaluation of physical and mechanical properties of rock for drilling condition classification Available to Purchase

This work deals with the investigation of physical and mechanical properties of selected rocks for condition of drilling categorization. Rock samples collected from five drilling locations were tested in the laboratory for uniaxial compressive strength, tensile strength, and Drilling Rate Index (DRI) using 1,100 kN compression machine, point load tester and miniature drill. Similarly, hardness, brittleness, Rock Abrasivity Index (RAI), penetration rate and bit wear rate were determined. The results showed that uniaxial compressive strength, tensile strength and Drilling Rate Index varied from 47.78 - 111.11 MPa, 8.09 - 19.44 MPa, and 20 - 52 respectively. The Nast point system chart was used to classify the rocks into drilling conditions. The drilling classification shows that the drilling condition of the rocks varied from slow to fast. The drillability characteristics of the rocks vary from extremely low to medium as specified by the Drilling rate Index (DRI). It was concluded that uniaxial compressive strength, texture and grain size, drilling rate index and Equivalent Quartz Content (EQC) are important parameters affecting drilling condition of the rocks.