This research focuses on the effect of molar concentration of CuI thin film deposited by mist atomization technique. The result shows the CuI thin film properties strongly depends on its precursor concentration. Thickness between 0.35 x 104 nm - 1.60 x 104 nm was obtained as the concentration increases. The increment of thickness affects the electrical properties which is the resistivity and conductivity of CuI thin film. The resistivity of about 101ω cm to 103ω cm was observed in those CuI thin films. For optical properties, the absorption coefficient and optical band gap of CuI was determined by using Tauc's plot. The high absorption coefficient of 106 m-1 is observed in those CuI thin films with bandgap between 2.84 to and 2.95eV obtained in this experiment.
Article navigation
1 June 2012
Research Article|
June 01 2012
Morphological, electrical and optical properties of γ- copper (I) iodide thin films by mist atomization technique
M. Amalina;
M. Amalina
1
NANO - ElecTronic Centre (NET), Faculty of Electrical Engineering, Universiti Teknologi MARA (UiTM)
Search for other works by this author on:
M. Rusop
M. Rusop
2
40450 Shah Alam, Selangor, Malaysia
Search for other works by this author on:
Publisher: Emerald Publishing
Online ISSN: 2515-8082
Print ISSN: 1708-5284
World Journal of Engineering (2012) 9 (3): 251–256.
Citation
Amalina M, Rusop M (2012), "Morphological, electrical and optical properties of γ- copper (I) iodide thin films by mist atomization technique". World Journal of Engineering, Vol. 9 No. 3 pp. 251–256, doi: https://doi.org/10.1260/1708-5284.9.3.251
Download citation file:
Suggested Reading
Effect of thickness on optoelectronic properties of ITO thin films
Circuit World (December,2020)
An investigation of physical properties and photovoltaic performance of methylammonium lead-tin iodide (CH3NH3Sn1-xPbxI3) solar cells
Microelectronics International (February,2021)
Properties of PZT thick films made on LTCC
Microelectronics International (August,2005)
Electrical resistivity and elastic wave velocity of sand–cement–inorganic binder mixture
Environmental Geotechnics (July,2018)
Modelling the electrical resistivity of concrete with varied water and chloride contents
Magazine of Concrete Research (February,2019)
Related Chapters
Dispersion effectiveness of carbon nanotubes in smart cementitious materials
ICE Themes Smart Concrete
Corrosion monitoring of reinforced concrete beam using embedded cement-based piezoelectric sensor
ICE Themes Smart Concrete
Measurement and modelling of conduction in carbon fibre-cement composites
ICE Themes Smart Concrete
Recommended for you
These recommendations are informed by your reading behaviors and indicated interests.
