... to AFRP application. Furthermore, after validation of experimental data by using ANSYS software, a parametric study was conducted to investigate the effect of pre-damage level on shear capacity of RC beams. For pre-cracked beams, loading was first applied until the cracking stage, followed by specimen...

...Parvathidevi A.; Naga Satish Kumar Ch Purpose This study aims to assess the efficacy of thermal analysis of concrete slabs by including different insulation materials using ANSYS. Regression equations were proposed to predict the thermal conductivity using concrete density. As these simulation...

... element (FE) software ANSYS. A parametric study is carried out to analyse the flexural and ductility behaviour of RC beams under various influencing parameters. Design/methodology/approach To develop and validate the numerical FE models, a total of four experimentally tested simply supported RC beams...

...Sabiha Barour; Abdesselam Zergua; Farid Bouziadi; Waleed Abed Jasim Purpose This paper aims to develop a non-linear finite element model predicting the response of externally strengthened beams under a three-point flexure test. Design/methodology/approach The ANSYS software is used...

... in the entire weldment. Design/methodology/approach The present work describes the modeling, simulation, Modeling of three-dimensional plate and mess generation process are carried out using ICEM CFD software. FLUENT 16.0 software is used for ANSYS simulation where various models are used for analysis...

... and axial flow blade was verified using ANSYS. Barlou’s condition for pipes, Lewis–Buckingham approach for gears and case-based analysis for axial flow blades were carried out and verified. Findings Pipes, gears and axial flow blades made form fly ash-based composites were found to exhibit improved...

... fibers are wrapped around the steel tubes and it is then modeled numerically using the ANSYS finite element program. Belytscho – Tsay shell element is used to model the composites, while a bilinear kinematic hardening model is used to model the steel tube. A proper contact algorithm is implemented...

... is done both theoretically and by FEM by using the well-known software ANSYS. Findings Results show that the radial stress is independent of the external radius-to-internal radius ratio, while the tangential stress increases. Practical implications In process industries like nuclear or chemical...

... by using ANSYS software. The nonlinear finite element analysis program ANSYS is utilised owing to its capabilities to predict either the response of reinforced concrete columns in the post-elastic range or the ultimate strength of a reinforced concrete columns reinforced by FRP bars. An extensive set...