Skip to Main Content
Article navigation
Purpose

The purpose of this paper is to demonstrate the n‐ZnO/p‐Si Schottky photodiodes.

Design/methodology/approach

A Zn film was deposited on silicon substrate by dc sputtering deposition technology from high purity zinc (Zn) targets. Then, the Zn films were then annealed under flowing oxygen (O2) gas environment in the furnace. ZnO nanorods morphologies have been successfully prepared through a simple method. No catalyst is required.

Findings

The structures and morphologies of the products were characterized in detail by using X‐ray diffraction, energy dispersive X‐ray, and scanning electron microscopy (SEM). According to experimental results, the current‐voltage characteristics of the device show the typical rectifying behaviour of Schottky diodes. The UV photocurrent measurement was performed using an UV lamp under a reverse bias.

Originality/value

The paper demonstrates that the n‐ZnO/p‐Si diodes exhibit strong rectifying conduct described by the current‐voltage (I‐V) measurement under a dark and illumination conditions.

You do not currently have access to this content.
Don't already have an account? Register

Purchased this content as a guest? Enter your email address to restore access.

Please enter valid email address.
Email address must be 94 characters or fewer.
Pay-Per-View Access
$41.00
Rental

or Create an Account

Close Modal
Close Modal