Application Model for Organic Solderability Preservatives Available to Purchase

Organic solderability preservative (OSP) coatings are not new. They have been used successfully with aggressive water soluble flux for assembly of through‐hole only PWBs. However, the multiple heating cycles required for mixed technology assembly and use of no‐clean low solids flux (LSF) for wave solder assembly have placed a greater demand on the solderability protection provided by OSPs. Wetting balance and float testing were used to evaluate numerous OSPs as well as the potential for these surface finishes to be used for ‘No‐Clean’ assembly. Although these laboratory evaluations revealed that OSPs are not as robust as SnPb, they did indicate the assembly processes and materials which could work with OSPs. Additional simulated assembly trials with test vehicles confirmed that thick OSP pre‐flux coatings interfere with soldering and that the solderability of surfaces with thin OSPs degrades when heated in an air environment. Since none of the OSPs evaluated outperformed the imidazole currently in use at AT&T, a no‐clean LSF assembly production trial with a mixed technology telecommunication circuit pack was conducted to compare imidazole with hot air solder levelled surfaces. The production trial and laboratory evaluations resulted in the development of an application model. The elements of the application model are not complicated: (1) use thin OSPs, (2) avoid baking, (3) use as aggressive a flux as possible, (4) apply as much flux as possible, (5) apply the flux where you want solder to wet, and (6) use nitrogen inerted processes whenever possible. Combination of these elements has led to the successful implementation of OSPs for no‐clean assembly. Funding for this effort was obtained through the National Center for Manufacturing Sciences (NCMS) Printed Wiring Board Interconnect Program.